About this 3D model

These feet screw straight into 3xxx series bookshelf speakers. They make use of the existing rubber foot provided with your speakers and raise the speaker by 24mm in total. Enjoy! They should be compatible with the following speakers: 3010 & 3010i 3020 & 3020i 3030i Assembly Print as many feet as needed for your requirements (in most cases 4) Remove the existing rubber feet from your speakers Press each rubber foot into the base of each printed foot This will be a tight fit, so a twisting motion might be needed Locate the feet holes on your speaker Screw each printed foot into each foot hole After several rotations, your printed foot should interface with the bottom of your speaker