About this 3D model

Quick 1 hour print of a John Lennon coaster! After printing, I realise that the layer of Grey is probably not necessary, but you can use it if you wish! If you decide to forgo the grey, replace it with white. Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm Filaments Used: - PLA Siddament Black Transmission Distance: 0.2 - PLA+ eSun Grey Transmission Distance: 1.4 - PLA META Sunlu White Transmission Distance: 9.6 Swap Instructions: - Start with Black - At layer #20 (0.92mm) swap to Grey - At layer #32 (1.4mm) swap to White for the rest.