About this 3D model

Large adjustable rolling pin, extending up to 70cm in width with a Ø58mm diameter. Allows for five height adjustments for precise dough rolling: 2mm, 4mm, 6mm, 8mm, and 10mm. Required Materials: - 1 Raw Beech Table Leg h710 Ø58 mm: https://www.castorama.fr/pied-de-table-h710-o58-mm-hetre-brut/3419932817001_CAFR.prd - 2 Brass Threaded Inserts L, 12 mm x l. 12 mm: https://www.castorama.fr/4-ecrous-cuvettes-laiton-l-12-mm-x-l-12-mm/3454975700323_CAFR.prd - 2 Stainless Steel Hex Head Bolts 6 x 25 mm Steps: - Trim the leg to the desired width if necessary. - Drill a 10mm hole in the center and screw in the brass inserts. - Drill two 5.5mm holes on each side, 20mm from the center (see template in the image). - Insert the hex head bolts into the piece that will hold the screw. - Finally, insert the piece with the thickness of your choice into each end of the leg, then the screw to secure it in place. 3D PRINTING PARAMETERS 0.2mm layer height 30% cubic infill Wall line count: 3 No supports Boost Me ? If you enjoy this project and find it useful, please consider leaving a small boost as a thank you, it's always appreciated and helps spread the word about my creations! ?