About this 3D model

Mr. Jack O. Lantern is expecting to come in to contact with many young unvaccinated children this Halloween, so to protect him and his family I have supplied him with a mask and a vaccine. I may have been a bit too late though. He has ended up with many green warts. It seems he's already come down with something. This syringe is a non-functional halloween prop. It has no moving parts. The plunger piece prints separately from the rest of it. In my case it just snapped in nicely to the top, but this will vary depending on your printer calibration. If it is too loose, a bit of krazy glue or two part epoxy should do the trick. If it's too tight, you might need to do a bit of sanding. For the "needle" at the end I held a finishing nail with a pair of pliers, heated up the end of it with a lighter, and pushed it in to place. NOTE FOR BAMBU PRINTERS: Because this was designed on an older printer, when printing on the Bambu the plunger doesn't snap in due to the improved accuracy. You will likely need to glue it on. The tree supports inside the syringe can be removed using needle-nose pliars, and when I had some supports break off in the far end I was able to poke it with a screwdriver to loosen it and get it out pretty easily. You could also just ignore them and leave them in there. Print Settings Printer Brand: Anycubic Printer: All-metal Mega Rafts: No Supports: Yes Resolution: 0.2 Infill: 20% hexagonal Filament: filaments.ca Econofil PLA White If you liked this design, please post a make!