About this 3D model

This is a pulley cover for the rear Y axis pulley on the Anycubic i3 Mega (I guess it's a gear attached to a stepper motor, not exactly a pulley, but that's what everyone is calling it so we'll go with that) I decided I wanted some pulley covers, and I found one that someone else made for the front, but not too many for the rear. I didn't like the look of the ones I did find for the rear, and the one I tried sat higher than I liked, and also didn't stay flat well because it was only held down on one side. This is a bit lower profile, and attached with two screws to help keep it lying flat. Check out my other Anycubic i3 Mega accessories at: https://www.printables.com/social/55222-tyler/collections/95780 Print instructions Printer Brand: Anycubic Rafts: No Resolution: 0.15 Filament: Filaments.ca EconoFil PLA (Black) Notes: Print it in the supplied orientation. It requires a lot more support than if you flipped it upside down, but it ends up looking a lot nicer this way in my opinion. If this design was useful to you, please post a make!