About this 3D model

I wasn't happy with the mounting hardware that comes with the Ikea Skadis Pegboard. The screws stuck out too far which interfered with mounting things on the board. They only supply two bottom pegs so the center is not well supported. So I designed these as replacements. Additionally I wanted to mount a panel to the side of my printer so I designed brackets that use medium 3M Command Strips. Updates: 2025-06-30: Added brackets to use medium command strips to mount the peg board. Required Hardware: Command Strip Bracket (M2 Heat set) and Support Peg (M2 Heat set): M2 x 14mm socket head screw M2 x 3.0mm L x 3.6mm OD or (4) M2 x 4.0mm L x 3.6mm OD Medium Command Strip Command Strip Bracket (M4 Screw) and Support Peg (M4 Heat set): M4 x 16mm button head screw and nut Medium Command Strip Mounting Washer (M4 Screw): M4 x 16mm button head screw