About this 3D model

This was a well designed model but I didn't like that it was too tall to use with the stock cover. While I was shortening it I saw room for some improvements so I made the following changes: Reduced overall height just enough to fit the stock cover Added nubs to retain the desiccant tray cover in the tray Split the cover in half so you can leave the bottom cover in place and load even more desiccant I super glued the bottom covers to the tray in my setup but it's not necessary. Printing tips: Print everything with the flat side down Supports are not needed Use a fine layer height and outside/inside wall ordering for best fit and finish