About this 3D model

Happy easter tir This project is a toy that would be find inside the easter egg. It is so fun because children and adults have to assembly it before playing. It's a tir that carries a big rabbit's statue than can be turn by a crank handle situated in the back of the tir. In order to mount this toy first you have to put toghether the back of it: there are six snap fit parts and I reccomend to pay attention to fit well all of them. Then you could mount the wheels with the two long posts, it can be quite difficult to fit but it is important to pay attention in order to make them stay in their positions. Then it's the turn of the crank handle and you have to put the gearwheel in the squared hole in the back of the tir and at the same time put the long post with the crank handle into the hole in the back and then put it on the hole of the gearwheel. After doing this put the large gearwheel in its support in the back of the tir, put the two small post in the holes of that, and finally put the rabbits statue in the two posts. So,print it and enjoy ;) .