About this 3D model

Are you looking to relocate your farming p1p printer spools to the front for easier access and visbility? If so, this kit does just that! I have 5 P1P printers in a shelving unit that made it difficult to access the rear spool holder for swaps and refills. With the printers being so close together I was unable to utilize any of the side mount options I came across in my search for a solution, so i made my own. The mount holds the spool off the p1p's frame and infront of the printers. This allows for quick access when using a shelving unit. Zero issues with loading from the front as long as your PTFE tubes are pushed all the way into the connectors. Parts required: x1 - PC4-m10 Link: https://www.amazon.com/dp/B086W9HZDK/ref=cm_sw_r_as_gl_api_gl_i_7HK7H4847JY52G8NFFCM?linkCode=ml1&tag=morallygreyka-20 x2 - #6-19 x 5/8 Link: https://www.amazon.com/dp/B00GDXXMUI/ref=cm_sw_r_as_gl_api_gl_i_E79K1P771589CK1HZQ8N?linkCode=ml1&tag=morallygreyka-20 x1 - PTFE tube . I used the spare section that came with my P1P's. May need to trim a few inches off as they all seem to be diff sizes Other recommended prints: I utilize this adapter I made to keep the PTFE tube from hanging, and to make sure while front loading the filament has no issues getting to the extruder. May not be neccesary but I have had it installed since I created the kit. Link: https://makerworld.com/en/models/29976#profileId-26360 I've probably made 25 differnet spool holder designs but nothing seems to track as straight as a basic cylinder with a flared end. Excited to see what others have for ideas with the spool holder. If you decide to make your own holder - you simply need a 25mm x 10mm base on it that will slide into the side mount - the rest is up to you and your imagination! Happy printing!