About this 3D model

Need a place to display all those Amiibo lying around your house? This 2 part print will allow you to place you Amiibo Buddies on your computer monitor! The two pieces fit together tightly so there is no need for glue! will take a little strength to get the pieces together but this was intentional, making the part strong! I printed on Tevo Michelangelo Sliced using Cura 3.2.1 Supports Touching build plate. 0.2 layer height 220 nozzle temp for initial layer 200 nozzle temp every layer after. 20 mm/s initial layer, follow by 60 mm/s for every layer after.