About this 3D model

A magnetic K Cup holder that can be attached to any magnetic surface most likely the side of a fridge which is where mine is currently located. They can be stacked on top of each other and will attach with magnets. I have updated the design with version 2.0 that includes friction fit magnet holes, plus 2 additional posts for the magnets for improved attraction to the metal surface. Version 2.0 For version 2.0, the magnet holes are specific for 10mm x 3mm magnets. The magnets fit into the holes tight so no glue should be needed. If you would like to glue the magnets I would recommend using E6000 glue to hold my magnets. These were the specific magnets that I purchased: https://www.amazon.com/dp/B09TPJ5FV2?ref=ppx_yo2ov_dt_b_product_details&th=1 Version 1.0 The spacing between the magnet stands and the backing is 3mm. The round place holders are 18.5mm round. The specific magnets I used are 18mm x 3mm which can be purchased here: https://www.amazon.com/dp/B0BDFFCSKT?psc=1&ref=ppx_yo2ov_dt_b_product_details The magnets overhang a little bit on the stands, but hold the model just fine. This is meant to be printed with the front face down without supports. I printed this with a .6 mm nozzle with .3mm layer height in Matte PLA.