About this 3D model

Did you know that hermit crabs need to fully submerge their shells in order to stay properly hydrated? Well I didn't! That is, until a friend of mine asked me to design and print some hermit crab pools for her little buddies (Flounder and Sebastian). Hermit crabs up to 4 inches should be able to completely submerge themselves in the pool to clean/bathe. The sides are designed to be climbable as they can use their little claws to climb the tank and jump in AND a ramp to provide an easy way for the hermit crabs to get out. Fun bubble design on the one side adds a bit of flair to your tank. I was almost able to get a water tight seal on these with the settings down below but it took a few tries to find the right settings for the specific PETG I was using (eSun). Your mileage may vary and it will likely depend on the brand of PETG used. Recommended Print Settings: 100% print-in-place, shouldn't need any special settings or orientation to make it work. The grooves on the side that act as a step-ladder are chamfered at the bottom to allow easy PiP. PETG .08 or .12mm layers 4-5 walls 15% gyroid infill Happy printing!