About this 3D model

I made this Cantilever Suspension to remove the rear shock towers so you can have more options for bodies on you Axial SCX-10. My Main goal was to use the stock shocks to keep the cost down. You will need to print the parts and purchase a couple nuts and bolts. But overall cost is really inexpensive. Plus if anything breaks you can always print a new part! Here is a list of parts that are needed to complete this project. Printed Parts:1 x Base1 x Mount Left - Glue to "Base" part1 x Mount Right - Glue to "Base" part2 x Pivot 12 x Pivot 22 x Spacer 12 x Spacer 2 Bought Parts:2 x M3 40mm bolt2 x M3 nut4 x M2 16mm bolt4 x M2 nut(you can use M3 bolts and nuts instead of M2, you just need to drill the holes a little bigger) Bought or made Part:2 x Push rods 28mm long from center of ball joint to center of ball joint--- For the Push rod (the connection between the cantilever itself to the axle), I used the extra rod ends that you get when you buy a SCX10