About this 3D model

Instead of holding my x-axis cables out of the way with a string - like I had been doing, I whipped up this quick little zip tie bracket. This fits down in the slot of your frame and is held in place with a single 4mm screw and a t-slot nut. There are two holes that allow you to run one or two zip ties over the top, or you can run one zip tie through both holes as I did in the photo. Nothing fancy, but this is a quick print that gets the job done! ---Another Sketchup Model - Debunking the Myth that Sketchup is Useless in 3D Printing