About this 3D model

Case for the Adafruit Macropad ( https://www.adafruit.com/product/5100 ) -Top layer acts as keyplate -6 degree typing angle -Props up the oled so that it's more visible -Requires 4x30mm countersunk m3 machine screws and 4xm3 nuts Updates: 10/2023 - Added some supports beneath plate on lower case (yet to be tested on a new print to stop the plate from flexing as much, especially when the knob is pressed in as this caused issues) 12/2021 - Changed plate and case tab thickness from 2mm to 1.5mm to match Cherry switch spec and cleaned up bottom case reinforcements to be flush with plate. 1/2021 - Added access to reset switch and STEMMA QT Connector via bottom case.