About this 3D model

This is my FFF process settings for Simplify3D for PLA. Printer: Robo3D R1 Hotend: Hexagon, temp = 208C Bed: Glass + hairspray, temp = 60C. I use other adhesion methods too which require different temps. Auto-Level: No Layer Height: 0.3mm (0.2mm is slightly different for the 1st layer's settings to improve bed adhesion) Note: I set my temps via my RepRapDiscount Full Graphic Smart Controller so I remove all Temperature profiles from my S3D process. The "3DPG" in the file name refers to the filament source, <a href="http://www.3dprintergear.com.au">3DPrinterGear</a>. I've included a small 10mm test cube, which is what I use to initially test various settings before moving on to more complicated calibration prints. I hope this proves to be useful.