About this 3D model

Filament: Gold MH Build Series PLA Filament - 1.75mm & Blue (Unknown Manufacturer) PLA Filament - 1.75mm A simple two color "Twisty Ring" designed in TinkerCAD and printed with a FlashForge Creator Pro. The model was sliced using Simplify3D's Dual Extrusion Wizard. The model was dropped through the build plate by 6.00mm (Z: -6.00mm) to create a flat surface and negate the use of support structures. Layer Height - 0.2mm Infill - 25% Supports - Yes; if you decide to print the entire model - No; if you drop the model below the build plate allowing for a flat surface. Amateur Tip - Buy a "Borosilicate Glass Plate Kit" for the FlashForge Creator Pro to save yourself from a lot of anger and confusion.