About this 3D model

Enhance the stability of your IKEA Skadis boards using these support feet, which effectively minimize wobbling through the use of double-sided tape. Print Instructions: No supports are necessary, though you might need to slightly clean the nut slot prior to insertion. Use any material that offers strong layer adhesion. Recommended settings: Layer height of 0.2mm using Jayo PLA+ white. Assembly: Insert an M4 nut into the slot on each foot. Depending on your printer's precision, you may need to apply slight force to ensure the nut fits snugly. Affix double-sided tape to the foot's flat surface. Installation: Use the original screw knobs provided with the Skadis board to attach both feet. Ensure your Skadis board aligns properly with the furniture. Peel off the protective film from the double-sided tape. Firmly press the Skadis board against the furniture for a few seconds to secure. Skadis Collection I am constantly developing more IKEA Skadis attachments. Check out my IKEA Skadis Collection here .