About this 3D model

Hello folks, you got a new printer and spent all your money on it, but where to put it? Don't get an ikea lack table they said, it's too unstable they said. Bullshit! You're getting actually a fine stable table, which is a lot stronger than you thought, for your bucks. Just a few modifications, and soon you can jump on it without a problem. (Disclaimer: Please don't try this at home, this stunt should be only performed by trained professionals.) Well, here you get a set of everything you need, actually a tad stronger than it was already. Screws needed: 88x 4,5x20mm And after you got more metal than wood, you can put your stuff on it and be happy. Example: I got one reinforced lack table, ontop a 15kg concrete plate and the p1p printer, stacked another ikea lack on it with a full filled ams (4x 1kg), stacked a second ikea lack on it to store my other filament (15x1kg). So you get a sense of whats holding up. ------------------------------------------------------------------------------------------------------------------------------- 10cm hexed stack extension: Ikea Lack - 10cm Erweiterung - Stapelbar - Massiv von 3Deen-Druck - MakerWorld 15cm massive stack extension: Ikea Lack - 15cm Erweiterung - Stapelbar - Massiv von 3Deen-Druck - MakerWorld ------------------------------------------------------------------------------------------------------------------------------- Boost Me A boost would be... terrific!