About this 3D model

Update 3/17/24: Mostly the same model, but cleaned up the base of under Mandalorian symbol where it meets square pipe. Trimmed unnecessary length slightly to reduce filament usage. Uploaded new Profile with dialed in settings for perfect finish of the emblem when printed emblem down against plate. Textured plate suggested for nice finish. Mandalorian Mythosaur Hitch Cover for 2" Receiver. Designed to fit 2" receivers. Was specifically tested and fits perfectly inside the hitch on my Super Duty that has a 2.5" to 2" adapter it. Printed in PETG use Bambu X1C with AMS Recommended settings: Print inverted, with Mythosaur face down. Minimal supports used under face from build plate only. No other supports needed. Used Basic PLA as the support material and interface and detached very easily after print completed. Top Shell: 4 Layers Bottoms Shell: 5 Layers Sparse Infill Density: 35% Wall Loops: 4 Uploaded both the base STL and the my 3mf project file with it prepainted and recommended settings. FYI: Ignore the ‘2-tone’ color square base. Was low on black so printed the stop you don't see inside with extra clear material I had available.