About this 3D model

Mix and match between the 13 pieces to fit your keyboard length and thickness! The design is mounted with 2-3 screws(depending if you print the shelf) and the different pieces are glued together.(1cm overlap for glue incorporated in the design) The middle pieces are thin as they don`t need to hold much weight The top hook simply falls into place and is only there to keep the keyboard from falling outwards i wanted a sleek and structural looking design so the wall don`t look ugly when the keyboard is not mounted I did not use any supports when printing my design,even the shelf supported itself( you may need to use a few supports if you go for some of the larger hooks) leave a comment with suggestions for extra modularity should the design not fit your keyboard!