About this 3D model
Snap-in version of cable clip. Just screw all clips in the wall and snap cable in. Basic variations are uploaded as models, all of the other ones are in the Zip file. There are total of 15 variations. Zip file contains all variations in folders grouped by cable size Hole for screw is 3 mm (3/32"). Clip for 10mm cable has 4 mm or 1/8" hole. All clamps have slightly rounded edges to reduce the possibility of damage to your cables. PETG is perfect for this as it's flexible. I don't recommend PLA as it is too stiff and from my tests it breaks after few usages. Before you ask: I chose hexagonal holes for screws because I noticed many people have issue with vertical round holes. The "blob" at the end of the clip serves to increase the adhesion of the layers and hopefully reduce the possibility of an over-tightened screw destroying the clip. If you need other sizes or dimensions, just ask in comments. I got you. ❤️ TODO: double side version Printing instructions Important: use arachne wall generator, as classic slicer will leave small hole in the neck of the clip and therefore reducing strength. 100% infill or 12 walls . Enable Avoid crossing walls . Pretty much use standard 0.2 mm standard profile. I recommend to use glue if you are printing thin ones without brim. Test one before printing large amount ;) Filename Model filename contains all dimensions: cable30 _ th1_29 .stl th1_29 - “neck” thickness cable30 - space for cable (diameter of inside hole) Neck thickness Thickness of the neck, higher value means more stiff and less flexible cable clip, but more durable. I tried to match default line width settings for 0.4 standard nozzle size. Variations: 0.84mm (th0_84) for 0.4 nozzle: 2 walls printed 1.29mm (th1_29) for 0.4 nozzle: 3 walls printed 2.19mm (th2_19) for 0.4 nozzle: 5 walls printed - very stiff, I do not recommend to use this for standard cables with insulation, but could be helpful with rods for example Cable size Size of heck/arc for cable. Variations: 4 mm (1/8") 5 mm (3/16") 6 mm (~1/4") - should fit Cat6 regular UTP (unshielded) cable 8 mm (5/16") 10 mm (~3/8")