About this 3D model

Highly optimised version to be printed easily and faster in vase mode! Recommended settings with 0.4 mm nozzle: CURA: Special Modes -> Spiralize Outer ContourS3D: Layer -> Single outline (Vase Mode)Slic3r/Prusa Slicer: Print setting -> Spiral vase NO SUPPORT! PS: Keep in mind that the most important factor to have better overhangs is the ratio between line width and layer height, LW / LH >= 5 If the model has problems, decrease the printing speed and increase the cooling if possible. PRINT SETTINGS 50% size ( 30 minute):Layer height: = 0.10 - 0.11 mmLine width/Extrusion Width: 0.55*Speed: 20 mm/sec WallMinimum layer time: 3sTemperature: +5CFan: 100%** 100% size (90 minute):Layer height: 0.12 - 0.13 mmLine width/Extrusion Width: 0.65*Speed: 25 mm/sec WallMinimum layer time: 6sTemperature: +10 C°Fan: 75%** 200% size (230 minute):Layer height: 0.16 - 0.17 mmLine width/Extrusion Width: 0.8*Speed: 30 mm/sec WallMinimum layer time: 10sTemperature: +15 C°Fan: 75%** *Yes, it is possible to change the width of the line, up to 0.8 mm even with a nozzle from 0.4 mm**Only for PLA and for better interlayer adhesion, but if the overhang are wrong, increased to 100 as well. (PETG 100%, ABS 25%) Optimisations: Head cut at a greater angle for better overhang Slightly lower shoulders for better overhang Reduced pit above the clavicle Adding venetian dimples Most proportioned body Increased definition between the legs and the buttocks Fixed the hole between legs