About this 3D model

This is a TF2 logo keychain based on the r/place logo created on Reddit.To get the multi colour I used the 'Change Filament at Z' Cura plugin. (https://www.thingiverse.com/thing:2077884) My printer settings were 0.2mm layer height, 0.24mm layer width.The layer count used to change filament is as follows:0 - Black6 - White8 - White10 - Orange13 - Yellow16 - White You can check and use different layers in your slicer and update the colors accordingly. Use infill greater than 40% to get good surface finish. Feel free to use this however please give proper credit.