About this 3D model

The RIP Gravestone is available in several models including a spooktastic Halloween decoration and a desktop holder for pencils, pens, markers, and more! RIP Gravestone (Halloween Decoration) One model includes glue holes for the insert, and another model without the holes. RIP Gravestone Pencil Holder One model includes glue holes for the insert, and another model without the holes. RIP Gravestone Insert Lay the insert over the face of the RIP Gravestone and press into place. Glue is not required but if you'd like to glue the insert into place please print the desired model with holes included. Gluing Instructions: Lay the RIP Gravestone on it's back so the lettering is facing upwards Add a drop of glue in each glue hole Lay the insert over the face of the RIP Gravestone and press into place Wait for the glue to dry before turning the RIP Gravestone upright Print Settings: Enable support with 30° threshold angle Concentric top surface pattern 0.08mm layer height for more detail 0.2mm layer height for a faster print Notes: Support is recommended to preserve some of the detail. It's minimal and easy to remove. Shown as printed at 0.08mm layer height