About this 3D model

This is a compact rack for the Raspberry Pi's. The boards are all placed vertically instead of horizontally. It consists of a single base and some small supports for each board. It's really easy to print and fits everywhere. Design advantages: Better heat management: the heat goes up and doesn't interfere with the board above because there isn't any. No need for fans: heat can freely escape vertically. Very compact design: this 5 slot stack has a length of just 14 centimeters. Board support: it supports a wide variety of boards and disks. It supports almost all the boards: B+ 2B 3B 3B+ Zero Zero W It also supports 2.5" Hard Disks or SDD's. There is enough space below for WIFI dongles (see the picture). At the moment it has space for 5 slots (if you need more slots just suggest it in the comments). Requirements: It only accepts Right Angle (90º) USB power connectors. Some 2.5mm screws for the supports. Each board needs 2 support sticks.