About this 3D model

These are easy to lose and break. I lost mine, then found it again and used it as inspiration to design this replacement from scratch. This slides on and fits perfectly in my test print, just tight enough, and also the screw holes are the same width, and width apart as the original bracket. If you would like to view the 3D model in colour in your browser and with optional AR, this is available directly at the Shapr3D viewer here . Printing Please print it in the orientation as per the main photo above. I used a brim just in case. Consider that if it is outside you may want more infill and also to use a more UV resistant material like ASA. An 0.4 nozzle and a 0.2mm layer height worked well for me. Support If you like our work please consider joining our club on Printables !