About this 3D model

All of the stands I have found are for the Traxxas Slash 4x4, so I took it upon myself to design a simple stand for my Slash to keep the wheels off the ground when in storage on the shelf. For assembly, you need the following: (8) M3x10-12mm screws. The "pre-drilled" holes are 12mm deep, so do not use anything longer than 12mm! This is a new model that has not yet been fully tested, so if you have any modifications you find beneficial to the design, feel free to reach out. Print Settings Printer Brand: Creality Printer: Ender 3 Pro Rafts: No Supports: Yes Resolution: .2mm Infill: 20 Filament: eSun PLA Plus Any Notes: The sides and braces do not needs supports however, I recommend you stand the top up on its end and print with supports. Category: R/C Vehicles