About this 3D model

Also check out my new version of the LYNX Blaster CALIBURN 4 - EU Edition NOTE! Please print this blaster quite colorfully, so that it differs greatly from real weapons. This is not a children's toy and please do not shoot at people or use it indoors! UPDATE 08.09.2023: Thanks to “ scr1tch “ for the tip on screw dealer GEDEX . I have expanded the BOM accordingly to save as much as possible on shipping costs. UPDATE 18.08.2023: I have made minor adjustments to the files “PGV_L” and “PGV_R”. The distances to the pump part “4DoomS” were minimized to remove the wobble. The new files are named PGV_Left_tight_EU and PGV_Right_tight_EU and can be used as an alternative. UPDATE 08.08.2023: Minor changes to the front grip (4DoomS_EU), so that the 4x M5x8 screws can now be omitted. 4x M5x10 can now also be used. The BOM has been adjusted and the STEP file has also been re-uploaded. I became aware of the original Caliburn 4 Blaster from Captain Slug some time ago, but put the project on hold due to a lack of inch-based accessories. However, after the popular streamer CHAOSDRUCKER presented the old Caliburn in the German Edition, I decided to undertake the project and redraw the complete blaster in variant 4 using metric units. My thanks still go to Chris a.k.a. CHAOSDRUCKER for researching the correct spring and for the motivation he provided to realize this project. Furthermore, I have also integrated the RMAX Barrel Shroud including the Rail Riser, a different Foregrip and the SCAR Suppressor. Both the sear and the trigger are designed for a spring mount but can also be replaced with the original version using a rubber band (included in the files). The images/renders show the Caliburn 4 both with and without the integrated Barrel Shroud. This is an optional add-on and not a must-have. Here is a good comparison of the Caliburns: Caliburn C4 vs Caliburn: I have endeavored to use mostly M3 and M5 heat-set inserts and ensured that all hardware is readily available from DIY retailers to keep costs down. I purchased the aluminum tube and all screws, nuts, and dowel pins individually from my local HORNBACH. Bill of Material (BOM): 8x 12x3 mm aluminum flat profile / flat bar 370mm - alternatively directly to 400mm - eBay Acrylic tube 40/36mm 1m tube - alternatively cut directly to size - eBay Cut to: 1x 185mm 1x 75mm 1x aluminum tube 15x1mm 1m (as barrel) 5x sealing ring 36/30 - 3mm line thickness (with suppressor 5x, without 3x) 3x sealing ring 13/10 -1,5mm line thickness 1x spring , if sold out alternatively these two springs #1 - K25 + spring #2 - K31 . The two springs (K25 & K31) are inserted into each other to be as close as possible to the original offered. 3x tension springs 6x25 0,5mm thickness 38x heatset inserts M3 41x M3x10 countersunk head or https://amzn.to/44fLHvr 2x