About this 3D model

Designed for Huawei Qi wireless charger CP60 Remodeled specifically for iPhone Xs Max (with phone case). Should also works for phones in similar sizes without resize the model. Tested on iPhone X, XS, XR. All working perfectly. 05.30.2019 UPDATE uploaded rotated version, just set Z position to -0.2mm (or more) to make sure a complete first layer //////WARNING Printing with bottom to the print bed (default model stance) is not recommended, the support will be hard to remove, and the structural strength is not optimal. (I had my lesson) Printing with back side surface to the print bed is highly recommended, you just need to rotate it manually to make the surface parallel to the print bed, set Z position value in minus a little bit to make sure it's 100% flat surface. Time and filament saving, support is much easier to remove (I use Cura tree support). With either side to the print bed will ensure the best structural strength, but have't tried personally. Welcome to be the first one. Print Settings Printer Brand: Creality Printer: CR10S PRO Rafts: No Supports: Yes Resolution: 0.28 Infill: 15% Category: Mobile Phone