About this 3D model

Summary This is a cable-holder which is intended to be sticked / supported by a wall insulation. My firewall, my WAN-bridge and other networking-stuff is on the attic below the roof. Also the cable where "air-routed", so basically just hanging around. I designed the clips to tidy up the cables and stick them to the styrofoam-insulation of the staircase. You can see one of the clips lying on the network-switch, while all the others hold the cables in-place right at the wall. Print Settings Printer Brand: Anycubic Printer: All-metal Mega Rafts: No Supports: No Resolution: 0.2 Infill: 20% Filament: Verbatim PLA white