About this 3D model

Summary I'd appreciate if you post some makes here! ;-) I bought the MCO Home - CO2 Sensor for measuring the air-quality in our bedroom during the night. Unfortunately it is intended to be mounted to the wall, which I did not want for two reasons: Ugly holes in the wall and where to route the cable? I may use it in any other room for a little monitoring, which is impossible when attached to the wall. So I designed this stand, which prints in ~4-5h does a decent job in holding it on any table or shelf. Please see the print settings - the STL orientation is not correct! Print Settings Printer Brand: Anycubic Printer: All-metal Mega Rafts: No Supports: Doesn't Matter Resolution: 0,2 Infill: 35% Filament: Verbatim PLA Notes: Print sideways (lying on one side), not as saved in the STL. If you print it sideways, the fibre-orientation is a lot better which is way more stable. You may use two of the typical computer-case hex screws which fitted my pre-printed holes perfectly.