About this 3D model

The module allows you to add GPS support in a microcontroller system (eg Arduino ), and the built-in NEO-6M system gives great possibilities and ensures high precision of measurement. The module has a built-in cell supporting RTC clock settings. The GY-GPS6MV1 module is a board containing the U-blox NEO-6M GPS receiver system. The tile also includes RTC backup battery, antenna connector (U.FL), voltage stabilizer and UART signal outputs. Properties GPS system: U-blox NEO-6M Transmission type: UART (lines Rx, Tx) Received band: L1 (1575.42MHz) Positioning efficiency: 3 m on average Drift: <0.02 m / s Reference system: WGS-84 Maximum height: 18.000 m Maximum speed: 515 m / s Acceleration: <4g Tracking sensitivity: -161 dBm Sensitivity of acquisition: -148 dBm Average time of "cold start": 38 seconds The average "warm start" time is 35 s Hot start time: 1 sec Average recovery time: 0.1s Working temperature range: -40 ° C to + 80 ° C Power supply range: from +3.5 V to +5.5 V Bus voltage UART: 3.3 V The soldering points allow the antenna to be mounted on the PCB Built-in RTC backup battery Built-in u.FL connector for antenna Module dimensions (without antenna): 36 x 26 x 4 mm Dimensions of the antenna: 25 x 25 x 8 mm Give me a like and follow my page. If you need help or you want to be printed this parts or customized in different way, just send me a message here. Thank you to support me and happy printing.