About this 3D model

THIS IS THE STAND ONLY!! This stand fits the "BULLET BILL / BANZAI BILL" model created by Martin Moore printed at 100% scale https://www.myminifactory.com/object/3d-print-bullet-bill-26743 I wanted a stand to put my Bullet Bill on so I could see more parts of the model. So I created this simple little stand. Hope everyone else enjoys the stand as well. To attach the stand simply: Unscrew the rear cap from the Bullet Bill print. Insert the stand over the small, non-thread diameter of the rear cap. Screw the rear cap back into the main body. Set the desired rotation of the print before you fully tighten the rear cap. The model is intended to be print with the base in the vertical orientation and the ring flat on the print bed. This allows the model to be printed without supports. It also puts the print lines in the correct direction for optimal strength of the stand.