About this 3D model

I designed a cutting claw with integrated recessed blade for cutting vegetation, ropes and small wire with the underwater QYSEA FIFISH ROV + Robotic Arm. I don't have yet an underwater drone but they amazed me. Will get a FIFISH soon! Here is my contribution to the community: DIN7981 tapping screws 2x d 2.9mm x L 13mm ( https://amzn.to/3WgKty1 ) 1x d 2.2mm x L 13mm ( https://amzn.to/3LYQ7Ah ) 1x trapezoid blade 52mm x 19mm x 0.5mm Trapezoid blades: https://amzn.to/45XhZxw I may earn a commission on qualifying purchases (at no extra cost to you) I printed the claw with Prusament PETG, 100% infill, 0.3mm layer height in DRAFT mode. No supports needed. Depending on your filament and settings you might need to use a small nail-file on the notch of the "cutting_claw_notch.3mf". Clean it up a little bit so the blade can enter the notch. Caution: Be careful and avoid cutting your ROV tether cable ;-)