About this 3D model

Linear Rail. X Linear Rail Mod. ---------------------------------------- Bobblejot Website Bobblejot GitHub Bobblejot Twitter Bobblejot Patreon ----------------------------------------note Have now eventually got around to uploading a version for the MGN12H rail as well, apologies to anyone that was waiting for the long delay. The new MGN12H version and the Updated MGN9H version now use a seperate standoff for the hotend to make print orientation easier. The MGN12H Mod adds an additional 3.5mm to the Y Offset on top of the Original 7mm Offset. ----------------------------------------Just a very simple X Linear rail mod using an MGN9H rail, Y offset is increased slightly due to the rail carriage but it isn’t by much just 7mm. You will need to file or grind a small bit of material away from the Extruder cover mounting lug where it catches the bottom M3x6mm mounting bolt. I bought a longer rail 330mm because i don't use the endstops, most suppliers will cut to any length you need though. You don’t need any additional hardware other than the rail itself and a few M3 T-Nuts and some Bolts: Alignment Jigs and Drill Guides ---------------------------------------- Materials: 1 x 320mm long MGN9H Linear Rail - Aliexpressor1 x 320mm long MGN9H Linear Rail - Aliexpress 8 x M3 T-Nuts - Aliexpress12 x M3x6mm Cap Head Bolts2 x M3x25mm Cap Head Bolts3 x M3 Locknut1 x M3 Washer And That’s it.