About this 3D model

Summary Model V1 has a wider bottle neck than V2. I think V2 fits a little better at the neck of the bottle, but you can also adjust the neck to a bottle later by heating it with a hairdryer if you want to. You need a slicer for the model that generates a tree support. I used Bambu Studio. Here I had to construct something on the ground so that the part of the bottle stays in the air. I have created V3 but I tried to pull the model from the support. Next time I will keep it in place. Today I created V4. It's a bit smaller, but it fits better on the neck of the bottle. I had also sometimes a slightly different tree support again by simply repositioning the model or the angle of the model to the build plate. I love this model. I hope you do too ;) Here is my Instagram post for this model: https://www.instagram.com/p/Cs4A_7sNH57/?igshid=MzRlODBiNWFlZA == Print Settings Printer: Bambulab X1C Rafts: No Supports: Yes Resolution: 0,200 Infill: 15% Filament: Bambulab PLA Metal Green