About this 3D model

Hi, here a little model of calibration cube It print Flat with no supports, When its printed, draw imaginaire dot lines on calibration cube paint. Its between these right dotlines you need to heat with a lighter underneath, back and forth until the temperature is just above 65 degrees. Now you can fold it over and push on it to a corner of a table or shelf. When it is cool down, you can heat between the other imaginary dot lines. And repeat the previous steps If you have any problem , let me know Look also my benchy paint Benchy paint NO SUPPORT by Mick23 - MakerWorld And please if you like it , share it and print it!!!! And show me your pictures. and rate the print profile please Like it if you want and follow me for other items. Comments welcome I added also a print profile in mirror mode if you want