About this 3D model

I collect knives, and needed a way to display them. The 3mf file has parts so you can adjust the number of shelves in the stand. There are cutouts for 8x1mm magnets. In retrospect, the magnets are not really strong enough, but they do keep most knives in place. The stand is designed for the pocket clips to clip into the frame which holds the knife nicely, but you have to remember that you clipped a knife in before trying to remove it from the stand. I think I would probably add rectangular magnets to the verticals for the clips in future versions. I printed at 100% infill with a Hilbert Curve top surface pattern for character. Enable support normal(auto) and remove small overhangs checked. Also, if you use a brim, set it to outer brim only. The supports snap out fairly easily if you snap off the outside, then push it through to the inside. Sorry no pictures of the support removal.