About this 3D model

I remixed the original project a bit. V2: - Decreased the left side of the base (now the x end-stop is triggered correctly) - Added some volume to the cable guide, to make it a bit stronger. - Same thing for the BLTouch mount. - Changed radius of the corners of the base, to have it match the corner of the red carriage. V3: - Added an insert, so the carriage will not bump into the x-belt tensioner nut while leveling. Currently I am printing with this mount, it is ok. If you are looking for the firmware, go to Marlin firmware for Creality CR-10 Max. I will write my settings when I finish testing. Almost there.