About this 3D model

Parts List FormFutura EasyWood 2x500g https://www.formfutura.com/shop/category/composite-materials-easywoodtm-179 Flexible fillament 50g for gasket https://www.formfutura.com/shop/category/flexible-materials-flexifiltm-tpe-163?order=name+asc Speakers https://www.audiophonics.fr/en/midrange-midbass-full-range/dayton-audio-ps95-8-speaker-driver-full-range-10w-8-ohm-86db-130hz-20khz-o9cm-p-9309.html Binding Posts https://www.audiophonics.fr/en/binding-posts/binding-posts-for-15mm-wood-panels-pair-p-10602.html Banana Plugs https://www.audiophonics.fr/en/banana-plugs/dynavox-gold-plated-banana-plug-o4mm-set-x4-p-13936.html Amp https://www.audiophonics.fr/en/full-digital-amplifier-fda/smsl-ad18-v31-digital-amplifier-bluetooth-nfc-tas5342a-2x-40w-subwoofer-out-8-ohm-p-11498.html Polyester wool https://www.audiophonics.fr/en/absorbents/visaton-polyester-whool-speaker-absorber-125g-p-6272.html Print instructions Print 4 shells for the speakers. Support is only needed where speaker driver is inserted (as seen on picture). Two shells should be printed as provided, but mirror the image in the slicer for the second two. Wood filament should be printed with 0.6mm nozzle (had clogging with 0.4mm) Print 2 gaskets for the speakers. Print 6 spike heads. Print 12 spike bodies. Two spike bodies are put togeather and inserted in the speaker head. TODO At the moment speaker has subtle indents for spikes but at the moment they are a bit to small for the ones i provided. (initial version of the spikes were smaller) I will modify the model to use these spikes in next version: https://www.audiophonics.fr/en/spikes/monacor-sps-35-black-spikes-black-set-x4-p-2166.html I will make a list of covers for the speaker that could be used if gasket is disregarded. Subwoofer design is in the process. Inspiration:https://www.youtube.com/watch?v=h-RSm97lkOU