About this 3D model

An alternate switch dock that uses the electronics from the original dock. The front part was printed standing up with Cura:s treesupport. The back part was printed laying on its back. The joycon strap rail was printed with the wide part facing down. The spaces are used to be able to use the tri-point screws from the original dock to fasten the pcb. I used three spacers to use the longer tri-point screw. The other screws used is some M2 screws and nuts, aswell as some small 2mm plastic screws left over from other electronics. *The printed version in the images does not have the recesses for the air intakes. The STL files is the updated version that do not block out the airflow.