About this 3D model

This is my laden jar. Print in vase mode. I printed this on my Ender3 with 0.2 layer height. To build you will need: Tin foil Duct tape Paper clip PVC pipe Paper towel Water Salt (2 pinches) Directions: Wrap tin foil around the bottom of the 3d printed part Tape it on Add salt to water and pour into printed part Put a small piece of duct tape over the top Straighten out the paper clip and poke it through the duct tape on the top - into the water To charge, rub the paper towel on the PVC pipe to create static electricity Grab the tin foil at the bottom of the printed part Pass the PVC pipe close to the paper clip to grab the static electricity and transfer to the salt water solution To discharge, put your thumb on the tin foil and your pointer finger on the paper clip (shocking)