About this 3D model

Summary This is a VESA mount adapter for the Rigol MSO5000 series Oscilloscope. Mounting the scope above your work surface increases flexibility, frees up space, and puts the scope at eye-level. Tool-less, quick-release, mounting of the oscilloscope, non-destructive, no permanent modifications Low-profile design, invisible from the front Full access to all ports/connectors Single-piece design with two small locking tabs to secure No supports needed to print - No overhangs greater than 45º Compatible with both 75mm and 100mm variants of the VESA mount Requires 4× M4 Hex Nuts and 4× 15mm (thumb)screws to mount to your stand Questions/comments? Leave a comment here or discuss on EEVBlog Forums . Print Settings Printer Brand: Bambulabs Printer: Bambu P1S Rafts: No Supports: No Resolution: 0.20mm Infill: 15% Filament: PETG (Tested) Notes: I suggest increasing infill density around the mounting holes. I ran into some minor bed adhesion challenges due to small contact area with build plate. A brim is recommended. For the locking tab, print with enough wall loops to ensure the center is completely composed to wall extrusion lines (no infill) for maximum strength. For a 0.4mm nozzle, 0.20mm layer height, 0.42mm line width, this is a minimum of 4 wall loops. I have included 3MF files with these settings for Bambu/Orca slicer. Post-Printing Instructions Print the main mount and 2 copies of the Locking Tabs. When placing the oscilloscope onto the mount, the two slots on the mount should perfectly line-up with slots on the back of the oscilloscope. Insert one locking tab in each of the slots and turn 90-degrees.