About this 3D model

Sonic, Tails and Knuckles wall art. Sonic - Sonics red shoes bits are printed separately, they should snap fit in place but if you have issues with tolerances try scaling them down slightly. Tails - No extra steps, just print Knuckles - Knuckles needs two bits of his shoes inserted after, the green and yellow bits. Again if they aren't snapping into place properly then try reducing the scale slightly and they should snap in. Wood filament works well for the skin colour if you do not have that colour available. Standard settings at 0.28mm layer heights works well. Hang up with blu tack or similar.