About this 3D model

Full build plate helmet. It should print upside down which is how I kept filament and print time down. A litle bit of scaring by me trying to take off the build plate a little to fast. Again the supports came off super easy and the inside supports I ran under warm water to loosen them up and it all pulled out. Printed in Bambu Slicer Bambu Matte White Filament Roughly 950g of filament 0.4 Nozzle 65 Degrees on bed 225 Degrees on nozzle Standard speed 25 hour print time 5 Minute support removal time by hand