About this 3D model

Probably the most iconic game prop in the entire Batman Arkham franchise, when I saw the official version I desperately wanted one but they were expensive and hard to find. Sometime later I got around to modeling the trophy and printing one and this is what I came up with. It may not be the best way to build one but it's how I got it done. It was designed to use stripped elwire that runs through channels in the question mark. Theres a compartment underneath to store electronics and a pathway to route the cables from the compartment to the lamp holder. You can reference this short video I took a while back to see what I mean by stripping the elwire. VIDEO: https://youtu.be/ahcQ8vJMmAA RECOMMENDED MATERIALS: El-Wire Green - https://amzn.to/3btooTQPLA Green - https://amzn.to/2JmqybMPLA Silver - https://amzn.to/3dzTFq4Raise 3D Printer - https://amzn.to/3aqoH1tSoldering Kit - https://amzn.to/2UCexnUAcrylic Paints - https://amzn.to/39mLNFcBob Smith Super Glue - https://amzn.to/3aqG5Dg NOTE: Some aesthetic and minor improvements were made to the design since some of the photos were taken nothing major.