About this 3D model

TIG/WIG Grinding Tool for Multitools What you need: Dremel / Parkside Multitool, 35mm Diamond Grinding Disk (f.eg. ebay) Each Head has 3 positions that can be used, each Position uses a different radius on the grinding disk Diameter available: 1.6mm and 2.4mm Angles available: 30 deg, 45 deg and 60 deg als well as a combi head Health and Safty Warning You do it on your own risk How to set up Step1 Insert the shaft of the grinding wheel into the collet chuck and tighten it slightly (so that it still move a bit and sticks out of the lower part). Screw the lower part of the tool onto the dremel. Step2 Put the grinding wheel onto the shaft (without the screw) and use the top part of the tool to press the grinding wheel and the shaft into the correct position. (When it fits to the lower part) Step3 Remove the lower part of the tool from dremel and tighten up the collet chuck. Step 4 Screw the lower part on dremel again, fit the grinding wheel with the shaft and screw the needed top part on. Use a 2.5mm, 1.7mm Drill to open up the holes if needed (or use a hot TIG elektrode) Ready to grind Other diameters and angles possible if needed. Same file als my design https://www.thingiverse.com/thing:3723973 More download availible Youtube