About this 3D model

Use Hex bits with a depth of 13 mm I have not confirmed that it works except for Vessel go-sai GS142665 【BOM】 All Type ・Vessel go-sai GS142665 65mm Double ended screwdriver bit Type1,2 ・M3 10mm capbolt ・M3 Hot Melt Nuts D4.6 X L5.0 Type2,3,4 ・Anex No.413 Magnetizer Type3,4 ・Super grue Type4,5 ・3.5mm Steel Ball ・M3 Hot Melt NutsD4.6 X L3.6 Created waist belt holster. It is exclusively for the ESH bit holder of TOP Industries, Inc. Fixed with M4-20mm bolt. This is a mini-stabilizer screwdriver that can be carried on a bit holder. It uses 65mm double-ended bits. It should work with most Japanese-made bits, but I have only confirmed it works with Vessel go-sai GS142665. It is legal to carry a minus screwdriver under 150mm without any reason. You can also carry it as a keychain or bag charm. There are five types. Type1: Fixed with screws It is fixed with an M3 10mm screw and a 5mm long insert nut. You need to remove the bolt to switch between plus and minus. Type1_N; This is a type that can be fixed with a hexagonal nut. Type2: Fixed with screws & magnet (Anex No.413) The handle of Type1 is shortened so that Anex No.413 magnetizer can be attached. It is convenient because the entire screwdriver can be attached to a magnetic wall. You can also remove the magnetizer and use it to hold the removed screws together. Type3: Magnetic retention (replaceable) The screw fixing function has been eliminated so that it can be replaced. Anex No.413 is attached with instant adhesive. AロンアルフアEXTRA Impact Resistant is recommended. The whole unit can also be attached to a magnetic wall. The holding power is weak, so if you walk around with it attached to the bit holder, only the grip part will be lost. It does not affect carrying it in your pocket. Type4: Steel ball latch (replaceable) This is the most complete model of all. The durability of the steel ball latch is still unknown. It can be revived by reheating, so it's fine. (Added later: Used at work for 2 months. It has become a little loose, but it's still okay.) It takes a lot of effort to make. 【How to make Type4 steel ball latch】 Use short insert nuts with L3.6. Insert the bit all the way in. Insert a 3.5mm steel ball and cover it with an insert nut. Push the insert nut all the way in while heating it with a soldering iron. ☆ Once the heated insert has gone all the way in, remove the bit while the insert is still hot. While the insert is still hot, lightly tap the insert with your fingertip. Once the insert has cooled down, remove and insert the bit. If it is not too loose, it is complete. If the bit cannot be inserted, or if it is too hard or too loose to remove and insert, repeat from ☆. It will become loose over time, so it may be better to make it a little harder to remove and insert at first. 【Type5】 It is basically the same as Type4, but the position of the ball is changed to be shallower with respect to the hexagonal shaft. The task of pulling out the bit while it is still hot has been eliminated. Insert the bit → insert the ball → push in the insert → cool down → pull out the bit I have created a waist belt holster. It is exclusively for the ESH bit holder of TOP Industries, Inc. It is fixed with an M4-20mm bolt.