About this 3D model

Description 1x1 Gridfinity bin. In my country, 6mm magnets are expensive, so I made a model using 5x1mm magnets . Use when strong magnets are not required. Other size models will be uploaded gradually. (I'm sorry that I'm not good at English.) Refinements Use 5mm magnets instead of 6mm magnets. No glue needed . Just insert it from the side and push it in until you hear a click. Few materials as possible. (example: 1x1x3 bin with label, the amount of material is less than 9.5g.) Prints faster. (example: 1x1x3 bin with label, the printing time is less than 27 minutes.) It has a little more capacity than the standard one. Printing ! Important ! Be sure to use a layer height of 0.25mm . Use 0.4mm nozzle and Line width of 0.42mm. Infill of 10%. Installation Insert the magnet from the side as shown in the photo. Push it in until you hear a click and complete. (No glue required.) To remove the magnet, use tweezers to push it out through the hole at the bottom.